What are the clock path timing checks?

Static timing analysis is a method of validating the timing performance of a design by checking all possible paths for timing violations under worst-case conditions. It considers the worst possible delay through each logic element, but not the logical operation of the circuit.

What is DMSA in PrimeTime?

Primetime provides an efficient way to analyze timing at different corners and different operating modes. MMMC (multi-mode multi corner) refers to performing timing analysis at various modes and corner. Distributed Multi-Scenario Analysis (DMSA) refers to timing analysis at different scenarios in a distributed manner.

What is PrimeTime Synopsys?

PrimeTime is a Static Timing Analysis (STA) tool from Synopsys. This is a simple description to use PrimeTime for VLSI class project. In Project #6, you will learn to find critical path using PrimeTime from your synthesized Verilog code. Go to your PrimeTime working directory first.

How is setup and hold time calculated?

Calculation of Setup Violation Check: Consider above circuit of 2 FF connected to each other.

1. Setup Slack = Required time – Arrival time (since we want data to arrive before it is required)
2. Where:
3. Arrival time (max) = clock delay FF1 (max) +clock-to-Q delay FF1 (max) + comb.

How do I stop a hold time violation?

For hold time violations:

1. Skew the clock to the start/endpoint (reverse of how to fix setup) to make the endpoint clock arrive earlier.
2. Insert cells along the path to increase the propogation time (insert chains of buffers)
3. Reduce the drive strength of cells on the path to make the transition time increase.

What is STA in VLSI?

Static Timing Analysis (STA) is one of the techniques to verify design in terms of timing. This kind of analysis doesn’t depend on any data or logic inputs, applied at the input pins. The input to an STA tool is the routed netlist, clock definitions (or clock frequency) and external environment definitions.

What is scenario in VLSI?

In ICCompiler, we create `scenarios` to specify the different corners and modes the design should operate on. In a `scenario`, you can have constraints which determine the mode of operation, and different libraries(or opertaing conditions) which determine the corners.

What is Prime Time tool?

PrimeTime is a stand-alone static timing analysis tool, which is based on the universally adopted EDA tool language, Tcl. The last section covers all relevant PrimeTime commands that may be used to perform static timing analysis, design debugging and writing delay information in SDF format.

What means PrimeTime?

Definition of prime time 1 : the time period when the television or radio audience is the largest also : television shows shown in prime time. 2 : the choicest or busiest time. 3 : big time sense 2 a pitcher not yet ready for prime time.

How is hold time calculated?

The average hold time is calculated by adding up all inbound customer call hold times and dividing that by the number of inbound customer calls answered by the agent or interactive voice response (IVR) system.

Why is hold time needed?

This duration is known as hold time. The data that was launched at the current edge should not travel to the capturing flop before hold time has passed after the clock edge. Adherence to hold time ensures that the data launched at current clock edge does not get captured at the same edge.