How do you test a hunter node?

Make sure the controller is in Idle Mode. Press and hold the PRG button until the icon is displayed. The station number will be displayed in the lower left side of the display along with the run time. Quickly press the plus or minus buttons to set the duration of watering time for the test program.

What does P err mean on a Hunter Pro C?

CAUSE – The “P ERR” message is displayed when the P/MV circuit is drawing too much current. Common causes include; a defective solenoid on the master valve, incompatible or defective pump relay, or wire run too long between the relay and controller.

How long does a hunter sprinkler controller last?

One of the components that you may need to replace regularly are the wires, often due to improper installation and corrosion. Valves will give you 10 to 15 years of service, while controllers 5 to 10 years.

How do you reset Hunter EC?

Resetting the EC controller

1. Press and hold down the , and buttons.
2. Press and release the RESET button in the lower wiring compartment.
3. Wait 2 seconds and release the , and buttons. The display should now show 12:00a. m.
4. All the memory has been cleared and the controller may now be reprogrammed.

What should I do if my Hunter irrigation does not start?

Call your dealer or Hunter installer. with a new battery. Time of day display is blinking. TROUBLESHOOTING GUIDE (cont.) PROBLEM CAUSES SOLUTIONS Automatic irrigation does not start at AM/PM of time of day not set correctly. Correct AM/PM of time of day. start time and controller is not in the AM/PM of start time not set correctly.

How do I use the Hunter SRC with the SRR?

The Hunter SRC is remote-ready for use with the SRR or ICR remote control system. The remote makes it possible for contractors and end-users alike to operate an system without having to walk back and forth to the controller. To utilize the SRR or ICR Remote Control System you must install the SmartPort® outlet.

What does a hunter weather sensor do?

A Hunter weather sensor or other type of micro-switch weather sensor NOTE: Complete this section only if you have a pump can be connected to the EC. The purpose of this sensor is to stop start relay installed. A pump start relay is a device that watering when weather conditions dictate.