How a mobile home furnace works?

The mobile home furnace provides heat through electric elements or the burning of a fuel such as natural gas or fuel oil. The air is circulated over and around the heat exchanger by a blower. The air is then sent into a duct system where it is delivered to the individual rooms.

How do you reset a furnace in a mobile home?

Follow these simple steps:

1. First, turn off the power supply to the furnace by turning off the breaker in the circuit box.
2. Locate the reset button on the furnace and press it to reset the furnace.
3. If the button is popped up, press it down.
4. Return the cover to the blower compartment and turn the power on.

How do I reset a Coleman furnace switch?

1. Turn the Coleman furnace system switch to the “Off” position on the electric service panel.
2. Locate the manual reset switch near the left side of your furnace blower.
3. Press the reset button, which you will find in the middle of the limit switch.
4. Turn the system switch to the “On” position.

Why is my Coleman furnace blinking red?

1 RED FLASH: This indicates that flame was sensed when there was not a call for heat. With this fault code the control will turn on both the inducer motor and supply air blower. A gas valve that leaks through or is slow closing would typically cause this fault.

How does a Coleman electric furnace work?

The Coleman electric furnace is specifically designed to be used in conjunction with a Coleman heat pump or Coleman air conditioner. The furnace contains a powerful blower fan that effectively circulates not only heated air but cooled air through the restricted ductwork of mobile homes.

Why is my furnace not kicking on?

The Pilot Light (Faulty Ignition Sensor) The pilot light or ignition sensor is usually the most common issue when your furnace will not ignite. Put the front panel back on, turn on the gas, and then turn the furnace back on. Turn up the temperature on your thermostat to see if your furnace will now fire up.